Water Pump 50mm

Water Pump 50mm
Weight: 28Kgs
Product Description: 50mm 30 Metre head 650 litres pm max flow
Application: Used for pumping water out of swimming pools, removing rain water from trenches, rivers and resoivoirs. Some are mounted onto water carts for pumping water out of tanks etc.
Safety: This product should not be operated unless proper training has been supplied to the person operating the equipment.
Personal protection gear includes: goggels, steel-cap boots, gloves, ear plugs, dust mask, hard-hat.
Starting:
  • Turn petrol on
  • Ensure machine is primed at all times
  • Open choke (butterfly closes to close off air flow)
  • Pull recoil 1/3 of way twice
  • Pull recoil full way until starts (usually 2 pulls)
  • Close choke (butterfly opens the air flow) 
Running machine: Always check oil level and air filters of the engine before starting the machine. Always prime the pump when first working with it, thersfter it will not be neccesary. Make sure the strainer is always fitted to the end of the suction hose.
Do's and Donts: Never try to work on the pump when the engine is running. Never start the pump up without water in the pump body.
Shutting Down: Turn On/Off switch off. Close fuel line.
Re-fueling:
  • Ensure petrol switch is off before refuelling.
  • Machine may not be running whilst refueling.
  • Do not smoke or use a cell phone whilst refueling.
  • Remove fuel cap and place in clean dry area within reach of the machine.
  • Pour the fuel into the tank.
  • Replace fuel cap and move fuel container.
  • Do not place any plastice bags around the fuel cap as this will close the breather hole in the cap.

Maintanance Checklist:

  1. Clean machine
  2. Drain oil and replace (20w50)
  3. Clean / replace spark plug
  4. Clean / replace air filter
  5. Check all bolts and nuts on machine
  6. Listen for bearing noises on machine
  7. Check that springs on governor are in place
  8. Clean carburetor and jets
  9. Check starter rope and coil
  10. Set rpm on 3000 rpm
  11. Check impeller for damage
  12. Check seals

Check all hoses & hose fittings. Make sure it is air tight

Testing Equipment Before Hire:

The equipment must be clean and must have a service tag attached to ensure that the workshop completed the standard service before returning the asset to the floor.

The equipment must be taken to the testing station applicable where you will test the machine in front of the customer whislt demonstrating the operation of the asset to the customer.

Ensure that the required safety attire is worn before beginning the equipment test and instruction to the customer and ensure that the customer is in a safe location.

Start the equipment as per the above instruction.

Demonstrate the operation of the equipment as per the operating instructions above.

Shut the equipment down.

The customer must sign that he has recieved training.

Enquiry about this product