Reversible Plate 500mm Honda GX270 - TMCR 3R9

Reversible Plate 500mm Honda GX270
Weight: 140Kg to 190Kg
Product Description: 9HP Petrol Engine V-belt driven Plate Size 500 x 750 32Kn
Application: Compaction of sandy and gravelly soil in trenches and foundations as well as paving applications
Safety:

This product should not be operated unless proper training has been supplied to the person operating the equipment.

Personal protection gear includes: goggels, steel-cap boots, gloves, ear plugs, dust mask, hard-hat.

Starting:
  • Turn petrol on
  • Ensure control lever is in neutral position before starting.
  • Open choke (butterfly closes to close off air flow)
  • Pull recoil 1/3 of way twice
  • Pull recoil full way until starts (usually 2 pulls)
  • Close choke (butterfly opens the air flow)
  • Increase the revs with the control lever before moving the machine forward or backwards
Running machine: Thickness of the layer to be compacted can be up to 250mm (100-250mm is ideal). Make sure soil is slightly moist (not wet and not dry) throughout the layer. 6-8 passes with the machine advancing at its normal pace will usually give you optimum compaction results- avoid "over compaction". Always run engine at Full speed when doing compaction work. Do not move the forward reverse control when engine is stopped or idling.
Do's and Donts: Avoid machine hitting against adjacent structures or rocks etc.
Shutting Down: Turn On/Off switch off. Close fuel line.
Re-fueling: Ensure petrol switch is off before refuelling.
Machine may not be running whilst refueling.
Do not smoke or use a cell phone whilst refueling.
Remove fuel cap and place in clean dry area within reach of the machine.
Pour the fuel into the tank.
Replace fuel cap and move fuel container.
Do not place any plastice bags around the fuel cap as this will close the breather hole in the cap.

 

Maintanance Checklist:

  1. Clean machine
  2. Drain oil and replace (20w50)
  3. Clean / replace spark plug
  4. Clean / replace air filter
  5. Check all bolts and nuts on machine
  6. Listen for bearing noises on machine
  7. Check / replace fan belt
  8. Check that pulley is lined up and tight
  9. Check that springs on governor are in place
  10. Clean carburetor and all jets
  11. Check starter coil and starter rope
  12. Set revs on 3500 rpm

Testing Equipment Before Hire:

The equipment must be clean and must have a service tag attached to ensure that the workshop completed the standard service before returning the asset to the floor.

The equipment must be taken to the testing station applicable where you will test the machine in front of the customer whislt demonstrating the operation of the asset to the customer.

Ensure that the required safety attire is worn before beginning the equipment test and instruction to the customer and ensure that the customer is in a safe location.

Start the equipment as per the above instruction.

Demonstrate the operation of the equipment as per the operating instructions above.

Shut the equipment down.

The customer must sign that he has recieved training.

Enquiry about this product