Concrete Saw 13HP GX350

Concrete Saw 13HP GX350
Weight:235Kgs
Product Description:13Hp Petrol engine, Push type, Blade Size 350mm Diamond Blade
Application:For cutting of expansion joints, neatening of slab/road edges, repairs to road/slabs and cutting of surfacesfor cable laying or replacing.
Safety:This product should not be operated unless proper training has been supplied to the person operating the equipment.
Personal protection gear includes: goggels, steel-cap boots, gloves, ear plugs, dust mask, hard-hat.
Starting:
  • Turn petrol on
  • Open choke (butterfly closes to close off air flow)
  • Pull recoil 1/3 of way twice
  • Pull recoil full way until starts (usually 2 pulls)
  • Close choke (butterfly opens the air flow)
Running machine:Always check the oil level of the machine. Check the blade cover and guide wheel are in place. Check the taps and hose to the blades regularly. Check V-belts are tensioned properly and in good condition. Never force the machine forward. Always use water when cutting. When starting up, make sure the blade is off the surface to be cut. Check the shaft bearings for wear(no play on shaft)
Do's and Donts:Never operate the machine with the blade cover in the "up" position. Make sure the blade is fitted in the correct direction and fastened properly. Do not run the machine without the recoil starter cover. Do not change direction while cutting.
Shutting Down:Turn On/Off switch off. Close fuel line.
Re-fueling:
  • Ensure petrol switch is off before refuelling.
  • Machine may not be running whilst refueling.
  • Do not smoke or use a cell phone whilst refueling.
  • Remove fuel cap and place in clean dry area within reach of the machine.
  • Pour the fuel into the tank.
  • Replace fuel cap and move fuel container.
  • Do not place any plastice bags around the fuel cap as this will close the breather hole in the cap.

 

Maintanance Checklist:

  1. Clean machine
  2. Clean / replace spark plug
  3. Clean / replace air filter
  4. Check all bolts and nuts
  5. Clean carburetor and jets
  6. Check starter rope and coil
  7. Drain oil and replace (20w50)
  8. Check fan belts
  9. Check that water pipes are not blocked

Set revs at 3000 rpm

Testing Equipment Before Hire:

The equipment must be clean and must have a service tag attached to ensure that the workshop completed the standard service before returning the asset to the floor.

The equipment must be taken to the testing station applicable where you will test the machine in front of the customer whislt demonstrating the operation of the asset to the customer.

Ensure that the required safety attire is worn before beginning the equipment test and instruction to the customer and ensure that the customer is in a safe location.

Start the equipment as per the above instruction.

Demonstrate the operation of the equipment as per the operating instructions above.

Shut the equipment down.

The customer must sign that he has recieved training.

Enquiry about this product